ZyXEL Communications ZyWall USG 50-H Series User Manual page 410

Chapter 26 Application Patrol/BWM
Figure 349 Application Policy Edit
The following table describes the labels in this screen.
Table 142 Application Policy Edit
LABEL
Enable Policy
Port
Schedule
User
From
To
Source
Destination
Access
410
DESCRIPTION
Select this check box to turn on this policy for the application.
Use this field to specify a specific port number to which to apply this policy. Type
zero, if this policy applies for every port number.
Select a schedule that defines when the policy applies or select Create Object to
configure a new one (see Chapter 31 on page 469
none to make the policy always effective.
Select a user name or user group to which to apply the policy. Select Create
Object to configure a new user account (see
details). Select any to apply the policy for every user.
Select the source zone of the traffic to which this policy applies.
Select the destination zone of the traffic to which this policy applies.
Select a source address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source.
Select a destination address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
destination.
This field controls what the ZyWALL does with packets for this application that
match this policy. Choices are:
forward - the ZyWALL routes the packets for this application.
Drop - the ZyWALL does not route the packets for this application and does not
notify the client of its decision.
Reject - the ZyWALL does not route the packets for this application and notifies the
client of its decision.
for details). Otherwise, select
Section 28.2.1 on page 446
ZyWALL USG 50-H User's Guide
for