ZyXEL Communications ZyWall USG 50-H Series User Manual page 415

Figure 351 AppPatrol/BWM > Other > Edit
The following table describes the labels in this screen.
Table 144 AppPatrol/BWM > Other > Edit
LABEL
Enable
Port
Schedule
User
From
To
Access
Source
Destination
Protocol
ZyWALL USG 50-H User's Guide
DESCRIPTION
Select this check box to turn on this policy.
Use this field to specify a specific port number to which to apply this policy. Type
zero, if this policy applies for every port number.
Select a schedule that defines when the policy applies or select Create Object to
configure a new one (see Chapter 31 on page 469
any to make the policy always effective.
Select a user name or user group to which to apply the policy. Select Create
Object to configure a new user account (see
details). Select any to apply the policy for every user.
Select the source zone of the traffic to which this policy applies.
Select the destination zone of the traffic to which this policy applies.
This field controls what the ZyWALL does with packets that match this policy.
Choices are:
forward - the ZyWALL routes the packets.
Drop - the ZyWALL does not route the packets and does not notify the client of its
decision.
Reject - the ZyWALL does not route the packets and notifies the client of its
decision.
Select a source address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source.
Select a destination address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
destination.
Select the protocol for which this condition applies. Choices are: TCP and UDP.
Select any to apply the policy to both TCP and UDP traffic.
Chapter 26 Application Patrol/BWM
for details). Otherwise, select
Section 28.2.1 on page 446 for
415