ZyXEL Communications ZyWall USG 50-H Series User Manual page 303

Table 114 Firewall > Session Limit > Edit (continued)
LABEL
User
Address
Session Limit per
Host
OK
Cancel
ZyWALL USG 50-H User's Guide
DESCRIPTION
Select a user name or user group to which to apply the rule. Select Create Object
to configure a new user account (see
rule is activated only when the specified user logs into the system and the rule will
be disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source address.
Use this field to set a limit to the number of concurrent NAT/firewall sessions this
rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default Session per
Host setting in the general Firewall Session Limit screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Chapter 18 Firewall
Section 28.2.1 on page 446 for details). The
303