ZyXEL Communications ZyWall USG 50-H Series User Manual page 169

Table 51 Network > Interface > PPP > Edit > Configuration (continued)
LABEL
Description
Connectivity
Nailed-Up
Idle timeout
ISP Setting
Protocol
Authentication
Type
User Name
Password ,/
Retype to
Confirm
Service Name
Server IP
Encryption
Method
Connection ID
Compression
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Metric
ZyWALL USG 50-H User's Guide
DESCRIPTION
Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and ()+/:=?!*#@$_%-
characters long.
Select this if the PPPoE/PPTP connection should always be up. Clear this to
have the ZyWALL to establish the PPPoE/PPTP connection only when there is
traffic. You might not nail up the connection if there is little traffic through the
interface or if it costs money to keep the connection available.
This value specifies the time in seconds that elapses before the ZyWALL
automatically disconnects from the PPPoE server.
Select the protocol that your ISP uses for the account. Options are:
pppoe - This ISP account uses the PPPoE protocol.
pptp - This ISP account uses the PPTP protocol.
Use the drop-down list box to select an authentication protocol for outgoing
calls. Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by
this remote node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
This field is read-only. It displays the user name for the ISP account.
Type your password. Then re- to make sure that you have entered is correctly.
This field is optional. It displays the PPPoE service name specified in the ISP
account. This field is blank if the ISP account uses PPTP.
Type the IP address of the PPTP server.
Select the type of encryption the ISP uses for the PPTP account. nomppe
applies no encryption.
Specify the connection ID for the PPTP account.
Select On to turn on stac compression, and select Off to turn off stac
compression. Stac compression is a data compression technique capable of
compressing data by a factor of about four.
Select this if this interface is a DHCP client. In this case, the DHCP server
configures the IP address automatically. The subnet mask and gateway are
always defined automatically in PPPoE/PPTP interfaces.
Select this if you want to specify the IP address manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
Enter the priority of the gateway (the ISP) on this interface. The ZyWALL
decides which gateway to use based on this priority. The lower the number, the
higher the priority. If two or more gateways have the same priority, the ZyWALL
uses the one that was configured first.
Chapter 8 Interface
characters, and it can be up to 60
169