ZyXEL Communications ZyWall USG 50-H Series User Manual page 143

Figure 124 Status > Cellular Detail
The following table describes the labels in this screen.
Table 39 Status > Cellular Detail
LABEL
Extension Slot
Service Provider
Cellular System
Signal Strength
Signal Quality
Last Connection
Up Time
Tx Bytes
Rx Bytes
Device
Manufacturer
Device Model
Device Firmware
ZyWALL USG 50-H User's Guide
DESCRIPTION
This shows to which slot the card is connected.
This displays the name of your network service provider or Limited Service when
the signal strength is too low.
This field displays the type of the network to which the ZyWALL is connected. The
network type varies depending on the 3G card you inserted and could be UMTS,
UMTS/HSDPA, GPRS or EDGE when you insert a GSM 3G card, or 1xRTT, EVDO
Rev.0 or EVDO Rev.A when you insert a CDMA 3G card.
This displays the strength of the signal. The signal strength mainly depends on the
antenna output power and the distance between your ZyWALL and the service
provider's base station. You can see a signal strength indication even when the
ZyWALL does not have a 3G connection (because the signal is still there even
when the ZyWALL is not using it).
This displays how good or bad the signal's strength is based on it's strength. For
example, "Good" and four signal icon bars display for a signal strength of "-80
dBm".
This displays how long the 3G connection has been up.
This displays the total number of data frames transmitted.
This displays the total number of data frames received.
This displays the manufacturer of your 3G card.
This displays the model name of your 3G card.
This displays the version of the firmware currently used in the 3G card.
Chapter 7 Status
143