Table of Contents
Advertisement
Chapter 8 Interface
If you set the filter to deny access and add the MAC address of a connected device, the
ZyWALL drops the device's connection immediately. However, if you set the filter to allow
only the specified MAC addresses, the ZyWALL does not immediately disconnect all
connected wireless clients.
To change your ZyWALL's MAC filter settings, click Network > Interface > WLAN >
MAC Filter > Add (or Edit). The screen appears as shown when you click Add. You cannot
edit the MAC address if you click Edit.
Figure 152 Network > Interface > WLAN > MAC Filter > Add
The following table describes the labels in this menu.
Table 65 Network > Interface > WLAN > MAC Filter
LABEL
MAC
Address
Description
OK
Cancel
8.12 WLAN Interface Station Monitor Screen
The station monitor displays the connection status of the wireless clients connected to (or
trying to connect to) a IEEE 802.11b/g card installed in the ZyWALL. To open the station
monitor, click Network > Interface > WLAN > Station Monitor. The screen appears as
shown.
Figure 153 Network > Interface > WLAN > Station Monitor
The following table describes the labels in this menu.
Table 66 Network > Interface > WLAN > Station Monitor
LABEL
Extension
Slot
Refresh
#
196
DESCRIPTION
Enter the MAC address (in XX:XX:XX:XX:XX:XX format) of the wireless station that is to
be allowed or denied access to the ZyWALL.
Enter a descriptive name for the MAC address entry.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select the location where the IEEE 802.11b/g is located.
Click this button to update the information in the screen.
This is the index number of the MAC address.
ZyWALL USG 50-H User's Guide
Advertisement
Table of Contents
Troubleshooting
