Intel 480T User Manual page 248

C H A P T E R 1 3
Table 63: Basic IPX Commands (continued)
Command
xping {continuous} {size <n>} <netid>
<node_address>
Table 64: IPX/RIP Configuration Commands
Command
config ipxrip add vlan [<name> | all]
config ipxrip delete vlan [<name> | all]
config ipxrip vlan [<name> | all] delay
<msec>
config ipxrip vlan [<name> | all] max-packet-
size <size>
config ipxrip vlan [<name> | all] update-
interval <time> {hold-multiplier <number>}
enable ipxrip
246
*
IPX Routing
Table 64 describes the commands used to configure the IPX route
table.
Description
Configures one or all IPX VLANs to run IPX/
RIP. IPX/RIP is enabled by default when you
configure the IPX VLAN.
Disables IPX/RIP on one or all interfaces.
Configures the time between each IPX/RIP
packet within an update interval. The default
setting is 55 milliseconds.
Configures the maximum transmission unit
(MTU) size of the IPX/RIP packet. the default
setting is 432 bytes.
Configures the update interval and hold
multiplier for IPX/RIP updates. This setting
affects both the periodic update interval of
IPX/RIP and the aging interval of learned
routes. The default update interval is 60
seconds. The aging period is calculated using
the formula (update-interval * multiplier).
The default multiplier is 3.
Enables IPX/RIP on the router.
Description
Pings an IPX node. If
specified, 4 pings are sent. The default
ping packet size is 256 data bytes.
Configure size between 1 and 1,484
bytes.
is not
continuous