Intel 480T User Manual page 101

C H A P T E R 5
Table 22: VLAN Configuration Commands
Command
config dot1q ethertype <ethertype>
config protocol <protocol_name> [add |
delete] <protocol_type> <hex_value>
{<protocol_type> <hex_value>} ...
config vlan <name> add port <portlist>
{tagged | untagged} {nobroadcast}
config vlan <name> delete port <portlist>
{tagged | untagged} {nobroadcast}
config vlan <name> ipaddress <ipaddress>
{<mask>}
config vlan <name> protocol
[<protocol_name> | any]
Virtual LANs (VLANs)
Description
Configures an IEEE 802.1Q Ethertype. Use
this command only if you have another switch
that supports 802.1Q, but uses a different
Ethertype value than 8100. You must reboot
the switch for this command to take effect.
Configures a protocol filter. Supported
<
•
•
•
The variable <
number between 0 and FFFF that represents
either the Ethernet protocol type (for
EtherType), the DSAP/SSAP combination
(for LLC), or the SNAP-encoded Ethernet
protocol type (for SNAP).
Adds one or more ports to a VLAN. You can
specify tagged port(s), untagged port(s).
Specify
from forwarding broadcast, multicast, and
unknown unicast traffic. By default, ports are
untagged.
Deletes one or more ports from a VLAN.
Assigns an IP address and an optional mask to
the VLAN.
Configures a protocol-based VLAN. If the
keyword
default VLAN. All packets that cannot be
classified into other protocol-based VLANs
are assigned to the default VLAN of that port.
> values include:
protocol_type
etype
llc
snap
hex_value
nobroadcast
is specified, then it becomes the
any
> is a hexadecimal
to prevent the switch
99