Intel 480T User Manual page 188

C H A P T E R 1 0
Table 45: Basic IP Commands (continued)
Command
disable loopback-mode vlan [<name> | all]
disable multinetting
enable bootp vlan [<name> | all]
enable bootprelay
enable ipforwarding broadcast {vlan <name>}
enable ipforwarding {vlan <name>}
enable loopback-mode vlan [<name> | all]
enable multinetting
186
IP Unicast Routing
Description
Disables loopback-mode on an interface.
Disables IP multinetting on the system.
Enables the generation and processing of
BOOTP packets on a VLAN to obtain an
IP address for the VLAN from a BOOTP
server. The default setting is enabled for
all VLANs.
Enables the forwarding of BOOTP and
Dynamic Host Configuration Protocol
(DHCP) requests.
Enables forwarding IP broadcast traffic
for one or all VLANs. If no argument is
provided, enables broadcast forwarding
for all VLANs. To enable,
must be enabled on the
ipforwarding
VLAN. The default setting is disabled.
Enables IP routing for one or all VLANs.
If no argument is provided, enables
routing for all VLANs that have been
configured with an IP address. The
default setting for
ipforwarding
disabled.
Enables a loopback mode on an interface.
If loopback is enabled, the router
interface remains in the UP state, even if
no ports are defined in the VLAN. As a
result, the subnet is always advertised as
one of the available routes.
Enables IP multinetting on the system.
is