Intel 480T User Manual page 221

C H A P T E R 1 1
Table 54: OSPF Configuration Commands (continued)
Command
config ospf lsa-batching-timer <timer_value>
config ospf metric-table <10M_cost>
<100M_cost> <1G_cost>
config ospf originate-default {always} cost
<metric> [ase-type-1 | ase-type-2] {tag
<number>}
config ospf routerid [automatic | <routerid>]
config ospf spf-hold-time {<seconds>}
config ospf vlan <name> area <areaid>
create ospf area <areaid>
enable ospf
RIP and OSPF
Description
Configures the OSPF LSA batching timer
value. The range is between 0 (disabled) and
600 seconds, using multiples of 5 seconds.
The LSAs added to the LSDB during the
interval are batched together for refresh or
timeout. The default setting is 30 seconds.
Configures the automatic interface costs for
10 Mbps, 100 Mbps, and 1 Gbps interfaces.
The default cost for 10 Mbps is 10, for 100
Mbps is 5, and for 1 Gbps is 1.
Configures a default external LSA to be
generated by OSPF, if no other default route
is originated by OSPF by way of RIP and
static route re-distribution. If
specified, OSPF always advertises the default
route. If
the default LSA if there is a reachable default
route in the route table.
Configures the OSPF router ID. If automatic
is specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is
Configures the minimum number of seconds
between Shortest Path First (SPF)
recalculations. The default setting is 3
seconds.
Changes the area ID of an OSPF interface
(VLAN).
Creates an OSPF area. Area 0.0.0.0 does not
need to be created. It exists by default.
Enables OSPF process for the router.
always
is not specified, OSPF adds
always
.
automatic
is
219