Intel 480T User Manual page 219

C H A P T E R 1 1
Table 54: OSPF Configuration Commands (continued)
Command
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid> <areaid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval>
config ospf add virtual-link <routerid>
<areaid>
config ospf add vlan [<name> | all] area
<areaid>
RIP and OSPF
Description
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
•
•
•
•
Adds a virtual link to another ABR. Specify
the following:
•
•
Enables OSPF on one or all VLANs (router
interfaces). The
to which the VLAN is assigned. The default
setting is disabled.
retransmission_interval
Default: 5
Minimum: 0
Maximum: 3,600
_
transmission delay
Default: 1
Minimum: 0
Maximum: 3,600
_
hello interval
Default: 10
Minimum: 1
Maximum: 65,535
_
dead interval
Default: 40
Minimum: 1
Maximum: 2,147,483,647
— Far-end router interface
routerid
number.
— Transit area used for
areaid
connecting the two end-points. The
transit area cannot have the IP address of
the backbone area.
<areaid>
specifies the area
217