Intel 480T User Manual page 191

C H A P T E R 1 0
Table 47: ICMP Configuration Commands (continued)
Command
config irdp [multicast | broadcast]
disable ip-option loose-source-route
disable ip-option record-route
disable ip-option record-timestamp
disable ip-option strict-source-route
enable icmp address-mask {vlan <name>}
enable icmp parameter-problem {vlan
<name>}
enable icmp port-unreachables {vlan
<name>}
enable icmp redirects {vlan <name>}
IP Unicast Routing
Description
Configures the destination address of the
router advertisement messages. The default
setting is
Disables the loose source route IP option.
Disables the record route IP option.
Disables the record timestamp IP option.
Disables the strict source route IP option.
Enables the generation of an ICMP address-
mask reply (type 18, code 0) when an ICMP
address mask request is received.The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of an ICMP
parameter-problem message (type 12) when
the switch cannot properly process the IP
header or IP option information. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of ICMP port
unreachable messages (type 3, code 3) when a
TPC or UDP request is made to the switch,
and no application is waiting for the request,
or access policy denies the request. The
default setting is enabled. If a VLAN is not
specified, the command applies to all IP
interfaces.
Enables the generation of an ICMP redirect
message (type 5) when a packet must be
forwarded out on the ingress port. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
.
multicast
189