Intel 480T User Manual page 211

C H A P T E R 1 1
Table 51: RIP Configuration Commands (continued)
Command
config rip rxmode [none | v1only | v2only |
any] {vlan <name>}
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name>}
config rip updatetime {<delay>}
config rip vlan [<name> | all] cost <number>
enable rip
RIP and OSPF
Description
Changes the RIP receive mode for one or all
VLANs. Specify:
•
•
•
•
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
Changes the RIP transmission mode for one
or all VLANs. Specify:
•
•
•
•
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
Changes the periodic RIP update timer. The
timer granularity is 10 seconds. The default
setting is 30 seconds.
Configures the cost (metric) of the interface.
The default setting is 1.
Enables RIP. The default setting is disabled.
— Drop all received RIP packets.
none
— Accept only RIP v1 format
v1only
packets.
— Accept only RIP v2 format
v2only
packets.
— Accept both RIP v1 and v2
any
packets.
— Do not transmit any packets on
none
this interface.
— Transmit RIP v1 format
v1only
packets to the broadcast address.
— Transmit RIP v2 format
v1comp
packets to the broadcast address.
— Transmit RIP v2 format
v2only
packets to the RIP multicast address.
.
any
.
v2only
209