Network Topology Selection - Motorola WiNG 5.5 Reference Manual

3 - 24 WiNG 5.5 Access Point System Reference Guide

3.1.2.1 Network Topology Selection

Advanced Setup Wizard
Use the Network Topology screen to define how the access point manages network traffic. The available modes are:
Figure 3-15 Initial Setup Wizard - Access Point Mode screen for Advanced Setup Wizard
• Router Mode
external network (WAN). Router mode is recommended in a deployment supported by just a single access point.
• Bridge Mode
Routing is generally used on one device, whereas bridging is typically used in a larger density network. Select Bridge
Mode when deploying this access point with numerous peer access points supporting clients on both the 2.4 GHz and
5.0 GHz radio bands.
NOTE: When Bridge Mode is selected, WAN configuration cannot be performed and the
Initial Setup Wizard does not display the WAN configuration screen.
1. Select Next. The Advanced Setup Wizard displays the
For more information, see
- In Router Mode, the access point routes traffic between the local network (LAN) and the Internet or
- In Bridge Mode, the access point depends on an external router for routing LAN and WAN traffic.
LAN Configuration on page
LAN Configuration screen to set the access point's LAN interface.
3-25.