Rf Exposure Guidelines; Safety Information; Reduce Rf Exposure - Use Properly; Remote And Standalone Antenna Configurations - Motorola AP-7161 Installation Manual

AP-7161 Access Point Installation Guide

RF Exposure Guidelines

Safety Information

The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio
devices.

Reduce RF Exposure - Use Properly

Only operate the device in accordance with the instructions supplied.

Remote and Standalone Antenna Configurations

To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or operating near
users at stand-alone desktop of similar configurations must operate with a minimum separation distance of 28 cm from all
persons.

Power Supply

Use only a power-over Ethernet 802.3at compliant solution. The required power rating is 25.5 Watts.

Wireless Devices - Countries

Country Selection

Select only the country in which you are using the device. Any other selection will make the operation of this device illegal.

Operation in the US

The use on UNII (Unlicensed National Information Infrastructure) Band 1 5150-5250 MHz is restricted to indoor use only, any
other use will make the operation of this device illegal.
The available channels for 802.11 b/g operation in the US are Channels 1 to 11. The range of channels is limited by firmware.
The FCC requires that the FCC ID label be placed on the outside of the device. If the device is placed in a protective enclosure
that requires tools to access, a permanent label with FCC ID must be placed on the exterior of the protective enclosure

Radio Frequency Interference Requirements - FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Do not operate a portable transmitter near unshielded blasting caps or in an explosive environment unless it is a type
especially qualified for such use.
• Do not operate the radio or attempt to transmit data unless the is connected; otherwise, the radio may be damaged.
35