Motorola WiNG 5.5 Reference Manual page 599

4. Select the Activate Wireless IPS Policy
parameters for configuration. Ensure this option stays selected to apply the configuration to the access point profile.
5. Within the Wireless IPS Status
setting is enabled.
6. Enter an Interval to Throttle Duplicates
interval represents the duration event duplicates are not stored in history. The default setting is 120 seconds.
7. Refer to the Rogue AP Detection
Enable Rogue AP
Detection
Wait Time to Determine
AP Status
Ageout for AP Entries
8. Refer to the Device Categorization
Select the Add icon to create a new Device Categorization policy, or select the
Categorization policy.
Figure 8-17 Wireless IPS screen - Settings tab
option on the upper left-hand side of the screen to enable the screen's
field, select either Enabled or Disabled to activate or de-activate WIPS. The default
in either Seconds (1 - 86,400), Minutes (1 - 1,400), Hours (1 - 24) or Days (1). This
field to define the following detection settings for this WIPS policy:
Select the check box to enable the detection of unsanctioned APs from this WIPS policy.
The default setting is disabled.
Define a wait time in either Seconds (10 - 600) or Minutes (0 - 10) before a detected AP is
interpreted as a rogue (unsanctioned) device, and potentially removed. The default
interval is 1 minute.
Set the interval the WIPS policy uses to ageout rogue devices. Set the policy in either
Seconds (30 - 86,400), Minutes (0- 1,440), Hours (1 - 24) or Days (1). The default setting is
5 minutes.
field to associate a Device Categorization Policy with this Wireless IPS policy.
Security Configuration 8 - 29
Edit icon to modify an existing Device