Motorola WiNG 5.5 Reference Manual page 346

5 - 260 WiNG 5.5 Access Point System Reference Guide
19. Set the OSPF Area
Area ID
Authentication Type
Type
Default Cost
Translate Type
Range
20. Select the OK
21. Select the Interface Settings
Figure 5-160 Device Overrides - Network - OSPF Area Configuration screen
configuration.
Use the drop-down menu and specify either an IP address or Integer for the OSPF area.
Select either None, simple-password or message-digest as credential validation
scheme used with the OSPF dynamic route. The default setting is None.
Set the OSPF area type as either stub, totally-stub, nssa, totally-nssa or non-stub.
Select this option to set the default summary cost advertised if creating a stub. Set a
value from 1 - 16, 777,215.
Define how messages are translated. Options include translate-candidate, translate-
always and translate-never. The default setting is translate-candidate.
Specify a range of addresses for routes matching address/mask for OSPF
summarization.
button to save the changes to the area configuration. Select
tab.
Reset to revert to the last saved configuration.