Wan Configuration - Motorola WiNG 5.5 Reference Manual

3.1.1.5 WAN Configuration

Typical Setup Wizard
NOTE: This option is only available when Router Mode is selected in the
Topology
Use the WAN Setting
access point to a wired local area network or backhaul.
Figure 3-8 Initial Setup Wizard - WAN Configuration screen of the Typical Setup Wizard
1. Set the following WAN parameters:
• Use DHCP - Select the radio control to enable an automatic network address configuration using external DHCP servers.
An automatic IP address is configured to the access point's WAN port using DHCP servers located on the WAN side of
the network.
• Static IP Address/Subnet
selected, this field is not available. When selecting this option, define
become enabled on the bottom portion of the screen. The provided IP address is assigned to the WAN interface of the
access point. The
• Select the port that is connected to the WAN
screen.
screen to define network address settings for the WAN interface. The WAN interface connects the
- Enter an IP Address and a subnet for the access point's WAN interface. If
Default Gateway is a router that serves as a access to other networks.
Default Gateway
– Select the port connected to the WAN.
Quick Start 3 - 13
Network
Use DHCP
information, as the field will
is