Address Setup - Toshiba RAV-SM563UT-E Service Manual

13-3. Address Setup

In case that addresses of the indoor units will be determined prior to piping work after cabling work
(Manual setting from remote controller)
<Address setup procedure>
• Set an indoor unit per a remote controller.
• Turn on power supply.
1
SET CL
TEST
Push + +
for 4 seconds or more.
2
(← ← ← ← ← Line address)
Using the temperature setup
12
set to the item code.
3
Using timer time
4
SET
Push button. (OK when display goes on.)
5
(← ← ← ← ← Indoor unit address)
Using the temperature setup
13
set to the item code.
6
Using timer time
7
SET
Push button. (OK when display goes on.)
8
(← ← ← ← ← Group address)
Using the temperature setup
14
set to the item code.
9
Using timer time
0001
to Master unit, and
10
SET
Push button. (OK when display goes on.)
11
TEST
Push button.
Setup completes. (The status returns to the usual stop status.)
2, 5, 8
END
<Operation procedure>
1
buttons simultaneously
/
/ buttons, set the line address.
/
/ buttons, set 1 to the line address.
/
0000
/ buttons, set
0002
to sub unit.
SET DATA
TEMP.
11
FILTER
RESET TEST
1
2 3 4 5
(Example of 2-lines cabling)
(Real line: Cabling, Broken line: Refrigerant pipe)
buttons,
buttons,
For the above example, perform setting by connecting
singly the wired remote controller without remote
controller inter-unit cable.
buttons,
Group address
Individual
Master unit : 0001
to Individual,
Sub unit
UNIT No.
R.C. No.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
6 7 8
– 118 –
OUT
IN
Line address 1
Indoor unit address 1
Group address 1
: 0000
In case of group control
: 0002
3, 6, 9
4, 7, 10
9 10 11
END
OUT
IN
2
1
2