Toshiba RAV-SM563UT-E Service Manual page 132

No. Part name
…
Drain pan 1. Take down the main unit and then treat
2. Remove the both side panels and
3. (SM802, SM1102, SM1402CT-E only)
4. Remove the set screws (9 positions) of
5. Remove the heat insulation on the
6. Remove the set screws
7. Remove the drain pan.
†
Vertical grille 1. Remove the drain pan.
2. Remove the set screws (2 positions) of
3. Remove the vertical grille.
‡
Louver motor, 1. Remove the side cover (right side only).
Lover drive
2. Remove the set screws (2 positions)
member
3. Remove the set screws (2 positions)
Procedure
the drain pan on the floor.
suction grilles.
Remove the set screw (1 position) to
fixing and reinforcing bar.
(Slide the reinforcing bar toward arrow
side on the right figure.)
fixing lower plate.
drain pan.
(SM562, SM802 : 1 position, SM1102,
SM1402 : 2 positions)
(SM562, SM802 : 1 position, SM1102,
SM1402 : 2 positions) of fixing drain
pan and main unit.
Pull it lower side.
fixing vertical grille.
and louver motor.
and louver drive member.
Screws
(Fixing lower plate and main unit)
Heat insulation
The screw that fixed drain pan and
main unit is under this insulation.
Screws
(Fixing drain pan and vertical grille)
Screws
(Fixing louver drive member and main unit)
Screws
(Fixing louver motor and louver drive member)
– 132 –
Remarks
Vertical grille
Louver drive Louver drive
member member
Louver Louver
motor motor
5 -4
5 -5
5 -6
6 -2
7 -3