Toshiba RAV-SM563UT-E Service Manual page 119

n Confirmation of indoor unit No. position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
ON / OFF
Push button if the unit stops.
2
UNIT
Push button.
1-1
Unit No. is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
button.
2. To know the position of indoor unit body by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are succes-
sively displayed, and fan, louver, and drain pump of the
corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
VENT
TEST
Push and
4 seconds or more.
ALL
• Unit No. is displayed.
• Fans and louvers of all the indoor units in the
group control operate.
2
UNIT
Every pushing
in the group control are successively dis-
played.
• The unit No. displayed at the first time indicates the
master unit address.
• Fan and louver of the selected indoor unit only
operate.
3
TEST
Push button to finish the procedure.
All the indoor units in the group control stop.
buttons simultaneously for
button, the unit numbers
FILTER
RESET TEST
UNIT
<Operation procedure>
1 2
END
1
FILTER
RESET TEST
3
<Operation procedure>
1 2
– 119 –
UNIT No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
SET DATA
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
3
END
1
Operation
2
2