Toshiba RAV-SM563UT-E Service Manual page 127

14-1-2. Concealed Duct Type
RAV-SM562BT-E, RAV-SM802BT-E, RAV-SM1102BT-E, RAV-SM1402BT-E
Be sure to turn off the power supply or circuit breaker before disassembling work
No. Part name

Electrical parts
box
‚
Multi blade fan
Procedure
1. Remove the air filter.
2. Remove the set screws (2 positions) of
the electrical parts cover.
3. Remove the electrical parts cover.
4. Remove the set screws (2 positions) of
the electrical parts box.
5. Remove the electrical parts box.
The electrical parts box is fixed to the
main unit with claws at the right side.
Lift up it once and pull toward you.
Then claws come off.
In this time, remove connectors of TA sensor,
TC sensor and TCJ sensor if necessary.
1. Remove the air filter.
2. Remove the connector of the fan motor
P .C. board.
3. Remove the hexagon head screw (562: 2,
802, 1102, 1402 : 3 positions) of fixing fan
assembly and main unit.
4. Remove the fan assembly from main unit.
The fan assembly is fixed to the main unit
with claws (3 positions) at the upper side.
Lift up it once and pull toward rear side.
Then claws come off.
5. Remove the set screws (4 positions) of
fixing fan case and fan cover.
6. Remove the fan cover.
7. Loosen the sets crew of the Multi blade
fan using hexagon wrench.
8. Pull the Multi blade fan towered fan case
side.
Then fans come off.
Screws
(Fixing electrical parts cover and box)
Electrical parts box
Fixing claw (Main unit)
Fan case
– 127 –
Remarks
Electrical parts cover
Screws
(Fixing electrical parts box and main unit)
Claw (Reverse side)
Hexagon head screws
(Fixing fan assembly and main unit)
Fixing hole (Fan assembly)
Multi blade fan
Fan case cover
Set screw
Screws (Fixing fan case cover)
1 -2
1 -3
1 -4
1 -5
2 -3
2 -4
2 -5
2 -6