Toshiba RAV-SM563UT-E Service Manual page 143

No. Part name
„
Inverter 1) Perform works of items of 1) to 5) of
assembly
2) Take off screw (ST1T Ø4 × 10L, 1 pc.) of
3) Perform discharging by connecting the
4) Remove various lead wires from the
5) Remove the hook for the partition plate
6) Remove the hook for the side cabinet
Procedure
the upper left part of the inverter cover.
• If removing the inverter cover under this
condition, P.C. board can be checked.
• If there is no space in the upper part of
the upper cabinet, perform works of
items 6) to 7) of (1) and remove the
partition fixing plate.
(ST1T Ø4 × 10L, 1 pc.)
CAUTION
Be careful to check the inverter because
high-voltage circuit is incorporated in it.
discharging resistance (approx. 100Ω,
40W) or plug of soldering iron to
terminals of the C10 too 13 (printed as
"CAUTION HIGH VOLTAGE") electrolytic
capacitor (760µF) of P .C. board.
WARNING
The electrolytic capacitor may not nor-
mally discharge according to error con-
tents and the voltage may remain. There-
fore, be sure to discharge the capacitor.
WARNING
For discharging, never use a screwdriver
and others for short-circuiting between
–
and electrodes.
As the electrolytic capacitor is one with a
large capacity, it is very dangerous
because a large electric spark will occur.
holder at upper part of the inverter box.
(lower left side).
(lower left side) and the screw, and lift up
the inverter assembly upward. (ST1T Ø4
× 10L, 1 pc.) In this time, cut off the band
bundling each lead wire.
REQUIREMENT
As each connector has a lock mechanism,
avoid to remove the connector by holding
the lead wire, but by holding the connector.

.
Screw
Inverter
assembly
Holder
–
+
,
+
Hook for the side
cabinet (lower left side)
– 143 –
Remarks
Inverter
cover
Inverter
assembly
Plug of
soldering iron
Left time:
10 sec. or more
Inverter assembly
Screw
Remove the connectors
with locking function by
pushing the part indicated
by the arrow mark.