Toshiba RAV-SM563UT-E Service Manual page 157

No. Part name
Š
1. Detachment
Fan guard
1) Perform the works in 1 of
2) Remove the air-outlet cabinet, and then
3) Take off screws fixing the bell-mouth.
4) Remove the bell-mouth.
5) Take off screws fixing the fan guard.
6) Remove hanging hook of the fan guard by
2. Attachment
1) Insert the extrusion at the upper side of
2) After attachment, fix it with screws.
3) Mount the bell-mouth by hanging hooks
4) After attachment, fix it with screws.
* Caution in assembling bell-mouth
Procedure
REQUIREMENT
To prevent damage on the products, treat
component on a corrugated paper, cloth,
etc.
put down it directing the fan guard side
downward.
(ST1T Ø4 × 10, 2 pcs)
(ST1T Ø4 × 10, 2 pcs)
pushing with a minus screwdriver.
the fan guard into the square hole of the
air-outlet cabinet, and then insert the
hanging hook. Fix the hanging hooks
(5 positions) by pushing with hands.
REQUIREMENT
Check that all the hanging hooks are fixed
to the specified positions.
(ST1T Ø4 × 10, 2 pcs)
(3 positions) at upper side of the bell-
mouth to the square holes of the air-outlet
cabinet.
(ST1T Ø4 × 10, 2 pcs)
• The size (color) of the bell-mouth at
upper side differs from that at lower side.
(Only for RAV-SP1102AT-E)
<In case of RAV-SP1102AT-E>
Upper side: Black
Lower side: Gray
<In case of RAV-SP1402AT-E>
Upper side: Black
Lower side: Black
 ‚
and in 1 of .
Minus screwdriver
Hanging hook
Hooks (3 positions)
– 157 –
Remarks
Bell-mouth
Air-outlet cabinet
Fan guard
Air-outlet cabinet
Square holes (3 positions)
Bell-mouth
Air-outlet
cabinet
Bell-mouth
Screws
(2 pcs)
Remove