Table of Contents
Advertisement
®
CADJET
3D Quick Start Guide
Inspecting the ink cartridges
Ink cartridges are supplied in housings which must be removed before
the cartridge is installed. To remove the cartridge housing, press back on
the tab and pull the cartridge forward.
Shipping Cap
Visually inspect each cartridge before installing. Make sure the blue tape
is intact on the jet area of the cartridge. (Do not remove the tape or
shipping cap at this time! They will be removed later.)
Inspect the IC chip on the cartridge. Make sure it is secure and in
approximately the location shown on the following figure. If any cartridge
is damaged, contact your authorized reseller for return/replacement of
the defective cartridge.
14
Pull back on
tab to remove
cartridge
Shipping Cap
Cartridge
Recognition
Chip
Flex
Contact
Area
Jet Area
Advertisement
Table of Contents
