Table of Contents
Advertisement
2
Press the button on the ink primer to activate the vacuum and draw
ink from the reservoir into the needle.
3
When ink is visible in the ink primer sight tube (should take 5-10
seconds), remove the cartridge needle from the ink primer and
quickly insert it into the hole in the top of the ink cartridge. Be sure
the needle is tightly connected by turning the fitting clockwise until
finger-tight.
4
Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not
overtighten. Wait 20 seconds for the ink pressure to stabilize.
5
Remove the cartridge from the carriage and remove the blue tape
from the jet area of the cartridge. CAUTION! Do not tilt the
cartridge up higher than a 30 degree angle. This could cause
the cartridge to lose pressure.
6
Rotate the cartridge one complete revolution counterclockwise to
ensure that there are no twists in the ink delivery line.
Check for ink on the jet plate. Continuous bleeding of the jet plate
indicates a loss of vacuum in the cartridge or an air leak in the lines.
A small amount of ink can be cleaned off the jet plate by dabbing with
a moist, lint-free cloth.
CADJET
®
3D Quick Start Guide
17
Advertisement
Table of Contents
