Table of Contents
Advertisement
®
CADJET
3D Quick Start Guide
7
Insert the cartridge into the carriage.
8
Repeat with each cartridge.
9
Press Utility Menu/Access Cartridge to return the carriage to the
service station.
10 Print the color test, prime test pattern and paper axis test as
described later in this guide.
11 If all colors look fine, go on to step 15. If any color drops out, prime
cartridges as necessary, using the ink primer. Place the suction end
of the ink primer over the jet area of the cartridge.
12 Make sure the ink primer is making good contact with the jet area.
Pulse the pump 3 - 5 times, until the ink is visible in the ink primer
sight tube. Maintain good contact between the inkjet plate and the
pump for an additional 5 seconds.
18
Switch
Sight
Tube
Advertisement
Table of Contents
