Table of Contents
Advertisement
®
CADJET
3D Quick Start Guide
Installing the cutter
A cutter located in the ink cartridge carriage cuts roll media. The printer is
shipped with the cutter installed.
!
Be careful when handling the cutter to avoid injury.
!
Cutting media with a worn cutter can cause the media to jam and create
a ragged cut line. Replace the cutter to avoid this condition. Do not cut
media on the printer with an external knife, as you could seriously dam-
age the platen and void the warranty.
Á
To install the cutter
1
Press Utility Menu/Access Cartridge button to move the carriage
out from the service station.
2
The cutter fits in the printer on the left side of the carriage. To remove
an older cutter, push the cutter lever down and pull it out. Install the
new cutter by pushing it into the slot until it clicks into place.
3
Press Utility Menu/Access Cartridge to move the carriage back
into the service station. This ensures that the cutter blade is in the
home position.
12
Advertisement
Table of Contents
