Table of Contents
Advertisement
7
Select the new printer, right click and select Properties and then
the PORTS tab. Click on Add Port and the following window will
appear:
8
Select LPR Port and then click on New Port. The following window
will appear:
9
Fill in the print sever IP address in the first line (192.0.0.194). Fill in
the parallel port queue name from the Pony 100 in the second line
(binary_p1) and click OK.
10 Click OK to close the Printer Ports window.
11 Select the General tab and click on Print Test Page. Wait a few
minutes and the Windows banner page will print. This verifies that
the driver works, the network address is correct and a printer "port"
has been established.
12 Click on OK to close the properties window.
CADJET
®
3D Quick Start Guide
192.0.0.194
binary_p1
37
Advertisement
Table of Contents
