ENCAD CADJET 3D Quick Start Manual page 29

3 If requested, insert your Windows OS disk(s) to copy required files.
Click on the Services tab and double click on Microsoft TCP/IP
Printing. Click on the Protocols tab when copying is finished.
4 Double click on the TCP/IP Protocol option and Specify an IP
address, Subnet Mask and gateway address for your computer.
Consult your system manager for these addresses.
NOTE: If you are setting up for a computer/printer standalone
configuration and your computer is not directly connected to the
Internet, use address 192.0.0.193. You may also use a subnet mask
of 255.255.255.0 with no gateway address. If you have more than
one LAN adapter card, select the one you want to use for TCP/IP.
Click OK twice to exit (you may need to restart the system). Make a
note of the address you choose. It must be unique to the computer
only – do not use it for any other devices on the network.
Installing the print server hardware
Before installing the print server, be sure that you have completed all other
aspects of printer installation as described in this manual.
Although the external print server is designed to withstand normal handling
procedures, you should exercise reasonable precautions when installing them,
particularly with regards to static discharge.
• Make sure that you are adequately grounded by touching a bare metal part of
the printer before starting the installation.
• To eliminate static charge buildup, avoid moving around the work area.
• Shut the printer's power OFF. The power switch is on the rear, left side of
the printer.
Á
To install the print server hardware
1 Connect the print server to the printer's parallel port.
2 Connect the modular power supply provided with the print server to
an appropriate AC power source.
3 Connect the power plug from the modular power supply to the
+5VDC input of the print server.
NOTE: At this point the LEDs on the 100/10 socket will blink for a
few seconds as the print server does a power up test.
CADJET ® 3D Quick Start Guide
29