Table of Contents
Advertisement
®
CADJET
3D Quick Start Guide
5
Double click on the Mac address to configure the print server with an
IP address. This will open a dialog box similar to the following:
6
Enter the IP address – if you are setting up a computer/printer
standalone configuration use an address that is unique in the
least significant part of the IP address (e.g. if you used
192.0.0.193 for your computer address use 192.0.0.192 for the
print server address). If you are going to connect into a larger
network, use an IP address that has been assigned by a network
administrator.
7
Enter the Subnet Mask - if you are setting up a computer/printer
standalone configuration use 255.255.255.0. If you are going to
connect into a larger network, use a Subnet Mask that has been
assigned by a network administrator.
8
Enter the Gateway address - if you are setting up a computer/printer
standalone configuration leave the address at 0.0.0.0. If you are
going to connect into a larger network, use a Gateway address that
has been assigned by a network administrator.
9
Click on the OK button and then click Close. Click on the TCP/IP
folder to open it. The XAdmin window should appear similar to the
following:
32
192.0.0.194
Advertisement
Table of Contents
