Connecting The Printer To Your Computer - ENCAD CADJET 3D Quick Start Manual

®
CADJET 3D Quick Start Guide
To clear a cartridge-related error, press Utility Menu/Access Cartridge to
move the carriage to the position which allows replacement of the ink cartridges.
Check to make sure you have the correct cartridges installed in each position,
that they contain the same type of ink and all cartridges are installed properly.
Install new cartridges if necessary.
Á
To clear cartridge recognition error:
1 Press Utility Menu/Access Cartridge to move the carriage to the
position which allows replacement of the ink cartridges.
2 Verify that four valid cartridges are installed. Replace any invalid
cartridges.
3 Press OK. If the problem has been corrected, the printer will
proceed with the print request. If the problem has not been
corrected, the printer will beep.

Connecting the printer to your computer

Your printer comes with a print server. You can use this print server to connect
your printer to your computer in a network configuration or you can connect your
printer directly to your computer without the print server.
Direct connect configuration
You will need an IEEE 1284 parallel cable to connect your computer directly to
the printer.
Á
To connect your computer directly to your printer
1 Attach an IEEE 1284 parallel cable from the parallel port on your
computer to the parallel port on the printer.
26