Table of Contents
Advertisement
Network configuration
This section covers only one network configuration for connecting the printer to
your PC: one PC is connected via a crossover cable to one print server, and not
to any other network.
If you know your situation is different, or if you try this section and it doesn't
work, you will need to contact your system administrator. Some tips for your
system administrator in this eventuality:
•
Don't place the print server in the middle of a large network. The printer
requires a lot of bandwidth and will not function properly if mixed with
regular network traffic. Subnet if you have to.
•
Make use of the XCD administrator's guide for the print server. It
contains comprehensive information on how to set up and administer
XCD devices. The Administrator's Guide is located on the System CD.
•
The print server's default IP address is 192.0.0.192; its default Subnet
Mask is 0.0.0.0; and its default Gateway is 0.0.0.0. You can configure
the print server by using a web browser to access it via HTTP. The
password is 'access'.
You will need
•
PC running Win95/98/ME/NT4.0/2000 with a 100baseT NIC installed
•
Win95/98/ME/NT4.0/2000 Operating System CD
•
CAT5 crossover cable (blue cable included with your print server)
•
Printer with print server
Computer Network Properties Setup
If your computer has already been set up as part of a larger network, you can
proceed to configure the print server with the XAdmin32 utility. If your computer
has not been set up for networking you will need to configure it using the follow-
ing steps.
Á
To configure network properties
1
Right click on the Network Neighborhood icon on the desktop and
select Properties from the popup menu. If you see TCP/IP as one of
the items listed, then it has been enabled on your computer. If TCP/
IP is enabled skip to step #4, if not, continue to step #2.
CADJET
®
3D Quick Start Guide
27
Advertisement
Table of Contents
