Filling The Ink Reservoirs - ENCAD CADJET 3D Quick Start Manual

Filling the ink reservoirs

The printer can support long, uninterrupted printing runs because of the large
capacity of each of the four ink reservoirs. The ink reservoirs are located in the
printer's left side cover.
A reorder line on the reservoir reminds you when to reorder ink. You may refill
above the fill line, but never higher than one inch from the top of the reservoir.
Note: Refill reservoirs when the ink level is approximately 50ml or 1/4 inch
from the bottom. Allowing ink levels to drop lower increases the risk of getting
air in the ink lines and losing pressure.
Á
To fill the ink reservoirs
1 Open the cover on the left side of the printer to access the ink
reservoirs. Unscrew and remove the cap of one reservoir. Open
only one reservoir at a time to prevent contamination with other ink
colors.
2 Make sure the ink color and type matches the reservoir and pour in.
Be sure there is no excess ink on the inside of the reservoir cap.
Replace the cap loosely on the reservoir - do not overtighten.
3 Repeat for the remaining reservoirs, then close the cover.
CADJET ® 3D Quick Start Guide
13