Connecting The Printer; Connecting The Power Cord; Setting Up The Printer - Bryce 30K User Manual

Connect the Address Printer to the parallel port of the
computer. The Parallel port is located on the rear of the printer
near the power switch.
To connect printer to the computer do the following steps.
1. Align the male end of the parallel cable or female end
of the serial cable connector to the port on the printer.
Push the cable connector completely in.
2. Secure the cable in place.
Use the two wire clips
located on each side of the
Parallel connector to snap
into the tabs on the
connector.
3. Align the other end of the
cable to the connector on
the computer and push into
the port.
4. Secure the cable in place.
Use the thumb screws on
the connector to screw into the hex jack screws on the
computer.
The power cord receptacle is located on the Electrical Bracket
Assembly along with the ON/OFF (I/O) power switch.
Connect the power cord to a grounded outlet. Avoid using
outlets that are controlled by wall switches and are shared
with other equipment.
1. Make certain the ON/OFF (I/O) power switch is OFF
(O). Push the female end of the power cord into the
power receptacle.
2. Plug the other end into a grounded power outlet.
Revision C 30K USERS MANUAL
P/N 90-00203-001

Setting up the Printer

Connecting
the Printer
Note
: AB switches are
not recommended for
operation with this
printer.
Connecting
the Power
Cord
Section 3 -
2