System Version (Factory Code:
010, System Number: 011, System
Level: 012, Software Version: 013)
This menu lets you view and identify panel
hardware and software version.
Note
Downloader programming
has not been investigated by
UL.
Note
A Downloader Phone Num-
ber must be programmed
and the user-programmable
option "Downloading" must
be on for remote downloader
programming to work.
Testing the
System
Note
Before testing, it is recom-
mended that you have cov-
ers on all modules (mounted
outside the cabinet) and the
panel cabinet door closed.
The testing environment
should match the system
working environment.
Concord 4 Series Systems
System Version Menu
The
menu lets you view and identify panel hardware and software. This infor-
SYSTEM VERSION
mation is primarily used for troubleshooting purposes.
To view and identify the System Version:
1.
Press A or B until the display shows
2.
Press # and the display shows
3.
Press B and the display shows
4.
Press B again and the display shows
5.
Press B again and the display shows
sion).
Downloader Programming
The panel can be programmed remotely using Enterprise. Use the information you recorded in
Appendix A to inform the downloading operator of the programming requirements for this sys-
tem.
Enterprise Downloader Programming
To initiate a Enterprise download session:
1.
Contact your download station and ask the operator to prepare to download to the panel.
2.
Make sure the system is disarmed.
3.
Press 8 + system master code + 7 + 0 (any), 1 (down), or 2 (up). The display shows
DOWNLOAD IN PROGRESS
If the alphanumeric touchpad does not display
loader operator to verify the downloader phone number. Also, make sure ToolBox is set up prop-
erly. Refer to the "Troubleshooting" section if the problem persists.
This section describes the following:
•
Basic System Commands
•
Testing Zones/Sensors
•
Testing Phone Communication
•
Testing Central Station Communication
•
Testing Outputs and Sirens
•
Testing Light Control
•
Testing the Energy Saver Module
•
Changing Fixed Display Touchpads
•
Testing the Audio Verification Module
•
Testing Cellular Backup Communication
You should test the system after installing or servicing and after adding or removing devices from
the system.
Refer to the "Troubleshooting" section if correct test results are not achieved.
WWW.DIYALARMFORUM.COM
SYSTEM VERSION
FACTORY CODE nnn*nnnn
SYSTEM NUMBER *nnnnnnn
SYSTEM LEVEL nnnn
SW VERSION nnnnx (
during the downloading process.
SYSTEM DOWNLOAD IN PROGRESS
(Default = N/A)
.
.
.
.
panel firmware ver-
SYSTEM
, call the down-
70