Table of Contents
Advertisement
2. Device status menu
Use this menu to view the status of all point ID devices connected to the DGP.
1. Enter 2 and press Enter to access the device
status menu (Figure 13), or if you do not
need to use this menu, press Enter to scroll
to
3. Device settings menu
2. Figure 14 shows the zone number/point ID
address, device category, and device type for
the first device on the list. A $ in front of the
device category indicates the device holds
settings other than the defaults. To scroll
through the list, press ENTER. To get status
information for a specific device, enter the
device zone (input) number and press
ENTER.
3. Figure 15 shows the status for the device.
Devices not known (learned) to the system
will show as Not Used. When devices share
the same address by mistake, the status will
read Multiple Devices. Correct the address
settings of the devices to cancel the fault.
Table 5 explains the codes used in the device status menu.
Table 5.
Device status codes
Code
MISC
PIR
GLASS
IO
Figure 13. Point ID device status menu
on page 14.
Figure 14. Device list
Figure 15. Device status
Category
Miscellaneous
PIR devices
Glassbreak devices
I/O devices
2. Device status
0 - EXIT, Menu:
17/0, IO T1
Input No:
17/0, Normal
* = -, # = +, 0 = EXIT
Type
T0
T0
T0
T0 (single input)
T1 (4I/4O)
13
Advertisement
Table of Contents
