GE Concord 4 Series Installation Instructions Manual page 53

Closing Reports (06101 - 06601)
When this setting is on, the panel sends a closing report to the central
station after arming the system.
Note
To use this feature, the Open/Close Reports settings under the
menu must be turned on for the specific CS Phone or Pager number.
No Activity (06102 - 06602)
When this setting is on, the panel sends a no activity report to the cen-
tral station when the activity timeout expires (see
).
TIMEOUT
Duress Option (06103 - 06603)
(Default = off) When this setting is on, the system can be controlled
using a programmed duress code (see
) and will send a duress alarm to the monitoring station.
DURESS CODE
Note
For UL Listed installations, Duress Option must be set to off.
Do not use a duress code unless it is absolutely necessary. Using duress
codes often results in false alarms due to code entry errors. If a duress
code is absolutely necessary, use it with the audio verification module
to reduce false alarms and accidental dispatches.
Force Armed (06104 - 06604)
When this setting is on, the panel reports to the central monitoring station when a
user "force arms" the system.
Note
Forced arming occurs if the user presses BYPASS when arming the system with open
sensors/zones protesting.
Auto-forced arming occurs when the user does not press BYPASS when arming the sys-
tem with open sensors/zones protesting, then leaves through an entry/exit door and the
arming protest period expires. This causes the system to automatically bypass the open
(protesting) sensors.
Auto-forced arming always reports to the central monitoring station.
Auto-forced arming has not been investigated by UL.
Concord 4 Series Systems
TIMERS—ACTIVITY
SECURITY—PARTITION N—
WWW.DIYALARMFORUM.COM
Reporting-Partition 1-6 (Default = off)
To turn Closing Reports off or on:
1. With the display showing
OFF/ON
The display flashes the entered setting.
PHONES
2. Press # and the display shows the new setting.
Reporting-Partition 1-6 (Default = off)
To turn No Activity reports off or on:
1. With the display showing
(current setting), press 1 (off) or 2 (on). The dis-
play flashes the entered setting.
2. Press # and the display shows the new setting.
Reporting-Partition 1-6 (Default = off)
To turn Duress Option off or on:
1. With the display showing
rent setting), press 1 (off) or 2 (on). The display
flashes the entered setting.
2. Press # and the display shows the new setting.
Reporting-Partition 1-6 (Default = off)
1.
2.
CLOSING REPORTS
(current setting), press 1 (off) or 2 (on).
NO ACTIVITY OFF/ON
DURESS OFF/ON
To turn Force Armed off or on:
With the display showing
(current setting),
ARMED OFF/ON
press 1 (off) or 2 (on). The display
flashes the entered setting.
Press # and the display shows the
new setting.
(cur-
FORCE
48