Led And Beeper Indications - Datalogic Gryphon I GD4100 Product Reference Manual

LED and Beeper Indications

The reader's beeper sounds and its LED illuminates to indicate various functions or errors on
the reader. An optional "Green Spot" also performs useful functions. The tables below list these
indications. One exception to the behaviors listed in the tables is that the reader's functions are
programmable, and may or may not be turned on. For example, certain indications such as the
power-up beep can be disabled using programming barcode labels.
Table 50.
INDICATION
Power-up Beep The reader is in the process of pow-
ering-up.
Good Read Beep A label has been successfully
scanned by the reader.
ROM Failure There is an error in the reader's
software/programming
Limited Scanning Indicates that a host connection is
Label Read not established when the IBM or
USB interface is enabled.
Reader Active The reader is active and ready to
Mode scan.
Reader The reader has been disabled by
Disabled the host.
Green Spot is on While in Stand Mode or Trigger
continuously Stand Mode the green spot shall
be on while in stand watch state.
a
Green Spot Upon successful read of a label, the
flashes momen- software shall turn the green spot
tarily on for the time specified by the
configured value.
a. Except when in sleep mode or when a
Product Reference Guide
LED and Beeper Indications
DESCRIPTION
Good Read LED Duration
LED
LED behavior for this indica-
tion is configurable via the
Good Read: When
feature "
to Indicate
"
Flashes
N/A
a
The LED is lit steadily
The LED blinks continuously
N/A
N/A
other than 00 is selected
Technical Specifications
BEEPER
Reader beeps four times at highest
frequency and volume upon
power-up.
The reader will beep once at cur-
rent frequency, volume, mono/bi-
tonal setting and duration upon a
successful label scan.
Reader sounds one error beep at
highest volume.
Reader 'chirps' six times at the
highest frequency and current vol-
ume.
N/A
N/A
N/A
N/A
331