Set Global Mid Label Id Characters - Datalogic Gryphon I GD4100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE
Set Anker Plessey Label ID Character(s)
Set Code 5 Label ID Character(s)

Set Global Mid Label ID Characters

Specifies mid-label ID that is added for transmission between the labels of a two-label pair.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above
to place the unit in Programming Mode, then the "Set Global Mid Label ID Character(s)"
barcode followed by the digits (in hex) from the Alphanumeric characters in
representing your desired character(s). If less than the expected string of 20 characters are
selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode by
scanning the ENTER/EXIT barcode again.
Set Global Mid Label ID Character(s)
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
Product Reference Guide
Label ID Symbology Selection — continued
DEFAULT
Set Global Mid Label ID Characters
Set Code 4 Label ID Character(s)
CANCEL
No Mid Label ID
Character (00)
Appendix D, Keypad
89