Intercharacter Delay - Datalogic Gryphon I GD4100 Product Reference Manual

References

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Go to
4. Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 36. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2 leading zeroes to yield two-
digits)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
300
This feature applies ONLY to the Keyboard Wedge interface.
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
page 63 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 36 for some examples of how to set this feature.
EXAMPLES
150ms
15
'1' and '5'
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Keypad, that represent
600ms 850ms
60 85
'6' and '0' '8' and '5'