Datalogic Gryphon I GD4100 Product Reference Manual page 321

Follow these instructions to select the delimiter character:
1. Determine the desired character, then find its hexadecimal equivalent on the
2. Go to
3. Scan the barcode: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 45. Source Radio Address Delimiter Character Setting Examples
STEP ACTION
1 Desired Setting
2
3
Scan Two Characters From
4
Appendix D, Keypad
5
Product Reference Guide
on the inside back cover. A setting of 00 specifies no delimiter character.
page 271 and scan the ENTER/EXIT PROGRAMMING MODE barcode to
enter Programming Mode.
the hexidecimal characters which were determined in the steps above. You will hear a two-
beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
No delimiter
character
Scan ENTER/EXIT PROGRAMMING MODE
Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 45 for some examples of how to set this feature.
EXAMPLES
, (comma)
'2' and 'C'
RF Features
ASCII Chart
Keypad, that represent
- (dash) / (slash)
'2' and 'D' '2' AND 'F'
319