Keypad Select - Datalogic Gryphon I GD4100 Product Reference Manual
General purpose handheldlinear imager or laser bar code readers
Hide thumbs
Also See for Gryphon I GD4100:
- Reference manual (428 pages) ,
- Product reference manual (364 pages) ,
- Quick reference manual (40 pages)
Table of Contents
Advertisement
Display Features
Keypad Select
This parameter specifies the character that has to be sent from the scanner when one of the three
keys are pressed. For example, when key1 is pressed a 0x3C '<' character is sent.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: DISPLAY KEYPAD SELECT.
4. Then read 3 HEX characters in the range 01-FE from the keypad in Appendix D, Keypad,
Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
Enable Keypad Select
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
278
Mode.
corresponding to the left, center and right keys respectively.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
$
DEFAULT
ENTER/EXIT PROGRAMMING MODE
Disable Keypad
CANCEL
3C3D3E
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Advertisement
Table of Contents
