Intercharacter Delay; Beep On Ascii Bel - Datalogic Gryphon I GD4100 Product Reference Manual
General purpose handheldlinear imager or laser bar code readers
Hide thumbs
Also See for Gryphon I GD4100:
- Reference manual (428 pages) ,
- Product reference manual (364 pages) ,
- Quick reference manual (40 pages)
Table of Contents
Advertisement
ENTER/EXIT PROGRAMMING MODE
Intercharacter Delay
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
page 292
See
for more information.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the
beginning.
CANCEL
00 = No Intercharacter Delay
DEFAULT
Beep On ASCII BEL
When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on
the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other
important event.
DEFAULT
Beep On ASCII BEL = Disable
Beep On ASCII BEL = Enable
Product Reference Guide
47
Advertisement
Table of Contents
