Linking A Bt Reader To A Pc - Datalogic Gryphon I GD4100 Product Reference Manual

Setup
BT Models only
Remember: The mandatory condition for establishing a new linking between a BT handheld
and a BT base is that the handheld is unlinked and they share the same security configuration. A
successful link is indicated by three ascending tones from the reader. A high-low-high-low tone
indicates the link attempt was unsuccessful. A single green LED flash after this tone indicates no
Base Station was discovered. Two green LED flashes after this tone indicates that more than one
Base Station was discovered and the reader did not link. Three LED flashes after this tone
indicate a security error.

Linking a BT Reader to a PC

The reader can optionally be linked to a Bluetooth-enabled PC with the serial port profile, in
either server mode or client mode, or with human interface device profile (HID).
Linking to a PC in Server Mode (BT Slave Mode)
To link a BT reader in server mode to a Bluetooth-enabled PC, follow these steps:
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the Link to a PC in Server Mode barcode to make the scanner visible to the host com-
3. Use the host computer's Bluetooth manager to "Discover new devices" and select "Data-
4. Select "connect" on the PC to link the reader to the PC. Use an RS-232 terminal program
Linking to a PC in Client Mode (BT Master Mode)
The reader can optionally be linked in client mode to a Bluetooth-enabled PC with the serial
port profile. To do this, follow these steps:
1. Ensure the PC or terminal can network with Bluetooth devices and that it is powered on.
2. Ensure that a COM port is assigned under Services within the Bluetooth setup menu.
3. Create a Link label that contains the address of the PC Bluetooth adapter.
26
puter..
logic Scanner." If you receive an error message, it may be necessary to disable security on
the device.
to see incoming data on the port designated by the computer's Bluetooth manager.
The Bluetooth address can be found under "Properties" within in
the Bluetooth setup menu.
NOTE

Link to a PC in Server Mode
Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300
