Label Gone Timeout - Datalogic Gryphon I GD4100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE
Double Read Timeout = 0.8 Second
Double Read Timeout = 1 Second

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for a new
label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds (2.55
seconds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a
trigger pull for each label that is read. See
examples for setting this feature.
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
Product Reference Guide
Double Read Timeout — continued
DEFAULT
Double Read Timeout = 0.9 Second
page 312
in "References" for detailed instructions and
016 = Timeout of 160 ms
Label Gone Timeout
CANCEL
93