Fax Receive Settings; Recall In Case Of Line Busy; Recall In Case Of Communication Error; Number Of Calls In Auto Reception - Oce cm4010 Facsimile Manual

Recall in Case of Line Busy

This program is used to set the number of recall
attempts and the interval between recall attempts when
a transmission is not successful due to the line being
busy or other reason.
The number of recall attempts can be set to any number
from 1 to 14, and the interval between attempts can be
set to any number of minutes from 1 to 15. Specify each
number with the
change quickly, keep your finger on the
If you do not wish to have recalling take place, select the
[Turn off Recall] checkbox
When this setting is enabled, note that your machine
will not re-attempt a call when manual transmission or
direct transmission is used.

Fax Receive Settings

The fax reception settings can be enabled or disabled to suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Receive Settings] key to configure the
settings.

Number of Calls in Auto Reception

This setting is used to select the number of rings on
which the machine automatically receives a call and
begins fax reception in auto reception mode. Any
number from 0 to 15 can be selected.
Specify the number with the
[OK] key. (To make the number change quickly, keep
your finger on the or
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.

Duplex Reception Setting

This used to have received faxes printed on both sides
of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
To enable this setting, select the checkbox
touch the [OK] key.
keys. (To make the number
or
and touch the [OK] key.
keys and touch the
key.)
and
Recall in Case of Communication
Error
This setting determines whether or not your machine will
re-attempt the call if a fax transmission fails due to a line
error.
The number of recall attempts can be set to1 and the
interval between attempts can be set to any number of
minutes from 1 to 15.
(To make the number change quickly, keep your finger
key.)
on the or
If you do not wish to have recalling take place, select the
[Turn off Recall] checkbox
When this setting is enabled, note that your machine
will not re-attempt a call when manual transmission or
direct transmission is used.

Auto Receive Reduce Setting

When a fax is received that includes the sender's name
and number, the received image is slightly larger than
the standard size*. This setting is used to automatically
reduce the image to fit the standard size.
To enable this setting, select the checkbox
touch the [OK] key.
If Auto Receive Reduce is disabled, the edges of the
image outside the standard size will be cut off.
However, the image will be clearer because it will be
printed at full size.
* Standard sizes are sizes such as 8-1/2" x 11" and
8-1/2" x 5-1/2" (A4 and B5).
182
key.)
and touch the [OK] key.
and