Table of Contents
Advertisement
Customizing settings
The Océ service technician changes the Océ 31x5E copy settings at delivery to
meet your company's or department's requirements. However, as time goes by,
you may want to adapt them to recent working procedures.
Please note that the standard settings for printing are the ones selected for the
job in the driver.
Changing standard copy settings
After warm-up, all functions are in their 'standard' or 'default' setting. You
could also press the correction button twice to return to the default settings.
The default settings have been defined by Océ and are therefore called factory
settings. For example, the 'Copy' function factory setting is set to '2-sided' by
default in order to comply with the EPA Energy Star criteria (see page 140).
You can adapt these default settings to meet company-specific or department-
specific requirements. By so doing, you select the settings which users need for
most of their jobs. You will only need to change these settings for specific jobs.
These settings are called company settings.
You can change the company settings back to the factory settings at any time.
Defining company settings
Press the correction button twice to clear any remaining settings and select the
1
required standard settings.
Start a copy job to check for any conflicting settings.
2
Access the key operator system (see page 14).
3
Open the 'Machine' section and select 'Defaults'.
4
26
Océ 31x5E Configuration and special maintenance
Advertisement
Table of Contents
