Polling Memory Transmission Using; F-Codes; Scanning A Document Into A Memory Box For F-Code Polling Transmission - Oce cm4010 Facsimile Manual

POLLING MEMORY TRANSMISSION USING

F-CODES

When your machine receives a transmission request from another machine, this function sends a fax stored in an
F-code memory box (polling memory) in your machine to that machine. The other machine must correctly specify the
F-code configured in your machine or transmission will not take place.
The document to be transmitted must be scanned into an F-code polling memory box.
Transmission request using an F-code
Sub-address: AAAAAAAA
Other
Passcode: XXXXXXXX
machine
System Settings for Fax: F-Code Memory Box
This is used to create memory boxes (polling memory) for F-code polling memory transmission.
A memory box name, sub-address, and passcode are programmed in each box.
☞
Programming an F-code Memory Box (Polling Memory)
SCANNING A DOCUMENT INTO A MEMORY BOX FOR
F-CODE POLLING TRANSMISSION
Follow these steps to scan a document into a memory box (Polling memory) for F-code polling transmission.
1
Ready to send.
Scan
Fax
Mode Switch
8 x11 1 / 2
Image
2
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Transmission
Speaker Resend
Send
Address Book
Auto
Sub Address
Special Modes
Quick File
Your machine
Polling memory box
(page 149)
Place the original.
Place the original face up in the document feeder tray, or face
down on the document glass.
Touch the [Special Modes] key.
File
114
Box name: BBBB
Sub-address: AAAAAAAA
Passcode: XXXXXXXX