Defining Settings For The Next Original; Copying Sets Of Originals Using 'Set Input' (Optional) - Oce 9800 User Manual

Defining settings for the next original

You can define the settings for each original you want to copy. When
'automatic feed' is enabled, you should bear in mind that the original is
automatically pulled into the scanner. If you want to be absolutely sure about
the settings that belong to an original, insert an original when the settings are
correct.
To increase your versatility at the scanner input side, you can ask your
Note:
key operator to switch off Automatic Feed. When using the scanner in
'non-automatic-feed' mode you must press the start button for each new
original to be scanned. This offers the possibility to change the settings for the
next original, even if you already put the original in place on the scanner feed
table.
Defining settings for the next copy job
Select all settings required for the next original.
1
Insert the next original.
2
If 'Automatic feed' is not active, press the start button.
If 'Automatic feed' is active, the original is fed automatically.

Copying sets of originals using 'Set Input' (optional)

If your system has a set memory, this is indicated by the memory indicator on
the left of the display (see figure 35 on page 45). Set memory allows you to sort
sets and copy long originals. A set of originals is a number of originals that
belong together. The order of the pages in each copy of the set is the same.
When copying sets of originals, you must first press 'set input' to enter the set
copy mode.
For each original in the set you may define specific settings, except the number
of copies. Confirm the end of the set by pressing the 'start' button after the last
original was fed.
44 Océ 9800 Copier/Printer User Manual